Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Idaho Falls, ID

Roll-Up Door Repair in Idaho Falls, ID

Sheet roll-up doors for storage units, sheds and warehouses repaired. Typical cost $150-$600.

Our roll-up door repair service in Idaho Falls, ID comes down to three things: a clear diagnosis, the right parts on the truck, and a door that is balanced and safety-tested when we finish. Sheet roll-up doors for storage units, sheds and warehouses repaired.

Signs you need roll-up door repair

  • The door is hard to lift or won't stay up
  • A dented or creased curtain
  • The latch won't lock
  • The door comes out of its guides

What usually causes it

  • Loss of spring tension
  • Impact damage
  • Worn latches and stops

What you can check yourself

  • Check whether the stops at the top of the guides are in place.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

How we handle roll-up door repair

  1. Inspect the curtain, guides and drum
  2. Adjust or replace the springs
  3. Repair the curtain or replace the door
  4. Replace latches and stops
  5. Test it

Typical roll-up door repair prices

$150-$600Typical range, parts & labor
1-2 hoursTypical time on site

What moves the price:

  • Door size, gauge and cycle rating
  • Operator type and controls
  • Parts availability for your model
  • Lift equipment and after-hours access

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Serving Idaho Falls, ID and nearby towns

Large daily temperature swings in Idaho work hinge screws and track bolts loose, which leads to noise, wobble and eventually an off-track door.

Technicians serve all of Idaho Falls (ZIP codes 83401, 83402, 83403, 83404, 83405 and more), plus Ammon (3.4 mi), Lincoln (4.7 mi), Iona (6.5 mi) and Shelley (7.4 mi). Call (833) 435-8883 to book a visit in Idaho Falls.

Roll-Up Door Repair: frequently asked questions

How much does roll-up door repair cost in Idaho Falls, ID?

Roll-Up Door Repair typically costs $150-$600 including parts and labor, and usually takes 1-2 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do roll-up door repair the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is roll-up door repair covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Idaho or Idaho Falls requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my commercial door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the commercial door is near the end of its life, replace it. Commercial doors are rated by cycles. If the door has reached its rated cycle life, has several damaged sections, or parts are no longer made, replacing it is often cheaper over the next few years. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Idaho Falls, ID

Sommer Garage Door Sensor Repair

Sommer openers, made in Germany, put the motor on a carriage that travels along the rail instead of hanging from the ceiling, so servicing them is a little different from a conventional opener.

Typical $100-$250

Hörmann Extension Spring Replacement

Hörmann is a German manufacturer of residential and commercial doors and openers with North American operations.

Typical $150-$350

Wayne Dalton Garage Door Cable Repair

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $150-$350

Haas Door Weather Seal Replacement

Haas Door, based in Wauseon, Ohio, makes residential and commercial sectional and rolling doors.

Typical $100-$300

Wayne Dalton Garage Door Installation

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $1,200-$4,500

Torsion Spring Replacement

Torsion springs replaced and wound correctly, with high-cycle upgrades available.

Typical $200-$450

Skylink Garage Door Opener Installation

Skylink makes openers and a wide range of universal replacement remotes and keypads.

Typical $350-$800

Wayne Dalton Commercial Garage Door Repair

Repairs for commercial sectional, overhead and service doors.

Typical $250-$1,000

Martin Door Extension Spring Replacement

Side-mounted extension springs replaced in matched pairs, with safety cables installed.

Typical $150-$350

Overhead Door Remote & Keypad Programming

Overhead Door-brand openers come from the same company as Genie, the Overhead Door Corporation.

Typical $50-$150

Allstar Opener Gear & Sprocket Replacement

Allstar openers are no longer made. Replacement remotes and many parts are still available, and we'll tell you when replacing the opener makes more sense.

Typical $125-$275

Wood Garage Door Repair

Rotted, warped or split wood sections repaired, sealed and rebalanced.

Typical $200-$700

Garage door stuck, noisy or broken?

Talk to a garage door technician in Idaho Falls, ID now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote